The accessories is introduced and the working principle of electromagnetic valve filter

by:AIRWOLF     2020-06-20
The introduction and the working principle of electromagnetic valve filter accessories accessories solenoid valve solenoid valve filter accessories factory, introduces filter YMF imported electromagnetic valve system ( Also called diaphragm valve) Is pulse bag filter soot blowing system of compressed air 'switch controlled by controller output signal of pulse injection, the dust removal parts of filter bag line by line ( Room) Blowing dust, keep the dust resistance within the range of Settings, to ensure the processing capacity of dust collector and dust collecting efficiency. Technical indicators work pressure. ~。 , the environment temperature ~ ( ℃) , the use of clean air medium, diaphragm life blowing more than ten thousand times. Mm connection thread mid-december ', mm in length, width, height mm, weight. Kg installation method of electromagnetic pulse valve input end ( IN) , and gas reservoir tube is connected to the output end connects to dedust box spray torch, connection between the screw thread are filled by tetrafluoroethylene ribbons fastening seal. The pulse electromagnetic valve is submerged type valve ( Also known as embedded valve) , it is directly installed on the air bag, has the very good direct injection, working air loss is small, air pressure is suitable for wide range of situations. Work pressure. ~. , the environment temperature ~ ( ℃) , the use of clean air medium, diaphragm life blowing more than ten thousand times. , working principle of the solenoid valve has closed cavity, in a different location to open a hole, each hole leads to different tubing, cavity valve is among, both sides are two electromagnets, which face the magnet coil electricity body will be attracted to which side, by controlling the movement of the valve body blocked or leakage of different discharge of oil hole, and the oil hole is always open, hydraulic fluid will enter the different oil drain, and then through the oil pressure to push oil just the pistons, piston drives the piston rod, piston rod drive mechanism. So that by controlling the electric current of the electromagnet to control the mechanical movement. Solenoid valve in the points for attention during the selection of a dust collector accessories the applicability of the solenoid valve fluid pipeline must be the solenoid valve series models and choose calibration medium. Electromagnetic valve is used in the fluid temperature must be smaller than the calibration temperature. General under CST electromagnetic valve to allow the liquid viscosity, is greater than the CST shall be indicated. Working pressure difference, line the high-pressure difference in less than. Should be chosen as ZS MPa, W, ZQDF, ZCM series and type of moving step by step straight acting; Differential pressure is greater than the minimum work. The MPa guiding type (optional Differential pressure type) Electromagnetic valve; Maximum working pressure difference should be less than the biggest calibration pressure solenoid valve; General solenoid valve is a one-way work, so should pay attention to whether there is a pressure difference, install the check valve. Fluid cleanliness is not high when the filters should be installed in front of the solenoid valve, general solenoid valve is better claim to medium cleanness. Pay attention to the traffic pore size and diameter; Two solenoid valve usually only switch control; Conditions permit, please install bypass pipe, easy maintenance; When there is water hammer to customize solenoid valve opening and closing time to adjust.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...