linear bearings

The causes of the action of regulating valve failure

by:AIRWOLF     2020-05-16
Reasons may be: there is no air or air pressure is insufficient; Actuator fault leakage; Regulating valve without output signal; Gas supply pipe rupture, deformation, joint damage leakage; Flow direction is not correct, with too much force, make the valve door falls off, take off the rod; High temperature valve is stuck, the damage. Solution: check the gas source, the collapse of the check valve door, reconfigure the clearance between the shaft and shaft sleeve, recalibration direction, to repair.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...